How to install the angle valve without water leakage

Kitchen faucets always need to be replaced, and the most troublesome part is the angle valve. If the angle valve is not installed correctly, water will always drip. If you want to install an angle valve, you need to talk about simple tricks

First, close the main water valve. Clean the interface of the angle valve to be installed. After replacing the original angle valve, carefully clean the scale and drain the remaining water in the pipe.

Choose a right-angle valve. Close the valve on the angle valve and identify where the two ports of the angle valve should connect.

Wrap the wires of the angle valve tightly, layer by layer, from inside to outside with raw tape. Note that usually more than 5 layers are required, don't be afraid of thick

Rotate the angle valve in the direction of the wire port connection and screw it into the wire port on the wall. Be careful not to apply force when screwing in. You can hand tighten it first. After tightening, you can use a wrench or other tool to twist the angle valve half a turn and try to adjust the position of the water outlet to a position that is convenient for connecting the water pipe.