What are the problems with the installation of different types of faucets

1. Installation of single-hole basin faucet

When purchasing a single-lever basin faucet, you should pay attention to the diameter of the water outlet. Most of the water in the market is hard pipe water, so you should pay attention to the height of the water outlet, and 35 work points from the basin down is the most suitable. When installing, a special angle valve must be selected, and the angle valve must be fixed with the hot and cold water pipes of the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember, you must not use other water pipes to connect, because if the water pressure is high, it is easy to fall off, leak water, and cause losses to you. If the water inlet pipe is too long and exceeds the water outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, you can moderately bend it to the position you need. Remember: Do not bend hard to 90 degrees or more. When installing the basin to drain, please don't forget to buy the small interface of the faucet (the faucet is shorted). Don't forget to flush the water pipes buried in the wall before you install.

2. Installation of shower and bathtub faucets (wall-mounted)

After you have purchased a shower, bathtub, and wall-mounted faucet, you can choose the appropriate height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe, so as not to cause damage to the faucet due to excessive water quality.

Concealed shower and bathtub faucets: After purchasing a concealed faucet, the valve core of the faucet should generally be pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before pre-embedding. If the wall is too thin, the valve core will not be able to be embedded. Do not remove the plastic protective cover of the valve core during pre-embedding, so as not to damage the valve core by cement and other chores during pre-embedding. In addition, when pre-embedding the valve core, you should also pay attention to the up and down, left and right directions of the valve core, so as to avoid the wrong valve core. If the size of the wall-mounted faucet deviates when the water inlet pipe is pre-buried, an adjustable crutch can be used to calibrate the position.

3. Installation of thermostatic faucet

Before installing the thermostatic faucet, please check whether the water pipes are hot on the left and cold on the right. Remember not to connect the hot and cold water pipes wrongly, so as to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Please do not forget to install the hot and cold water filter when installing the thermostatic faucet.

4. Installation of single hole kitchen faucet

It is required to be stable, because the kitchen faucet is used frequently, and it is moved around easily, so it is easy to loosen, so the lock nut must be tightened. At present, there are some faucets on the market that are fixed with a screw pipe and a larger nut. This kind of stabilization effect is very good. If the problem of water removal and pulling can be solved, it will be a popular trend in the future.